RDDS1-230x190-S-B-CA 尺寸工程图

尺寸工程图 RDDS1-230x190-S-B-CA:俯视图(含马达连接线缆出口、量测系统连接线缆出口)、B-B 剖面图(外径 230 mm)、3D 透视图及索引位置图

系统资料(System Data)

以下系统资料适用于 RDDS1-230xH 全高度系列(H = 115 / 140 / 165 / 190 mm)。数值容差范围:±5%。

系统资料 符号 单位 RDDS1-230x115 RDDS1-230x140 RDDS1-230x165 RDDS1-230x190
直径 × 高度(Diameter × height) DxH mm 230x115 230x140 230x165 230x190
载台板内径(Inner diameter: stage plate) dsp mm 115 115 115 115
底板内径(Inner diameter: base plate) dbp mm 140 140 140 140
量测系统 1 Vpp(Measuring system 1 Vpp inc 24000 24000 24000 24000
轴承极限转速(Limiting speed of bearing) nlim rpm 240* 240* 240* 240*
质量(Mass) m kg 15.8 20.5 25.3 30.0
惯性矩(Moment of inertia) J kgm² 0.027 0.035 0.042 0.049
轴向/径向跳动(Axial/radial runout) SR/KR µm ±10 ±10 ±10 ±10
绝对精度(Absolute accuracy) abs arcsec ≤30 ≤30 ≤30 ≤30
重复精度(Repeatability) rep arcsec ≤5 ≤5 ≤5 ≤5
轴向载荷(Axial load) Fax N 925.0 925.0 925.0 925.0
径向载荷(Radial load) Frad N 162.0 162.0 162.0 162.0
倾覆扭矩(Moment impact / tilting torque) Ttilt Nm 47.3 47.3 47.3 47.3

* 少数情况下,极限转速受马达绕组版本限制。(*In few cases the limiting speed is limited by the winding version of the motor.)

旋转系统外壳最高温度预设不得超过 60 °C。(On housing of rotary system the maximum temperature of 60 °C must not be exceeded by default.)

数值容差范围:±5%(Tolerance range for values: ±5%)

规格如有变更,恕不另行通知。(Subject to modification without previous notice.)

马达规格:与绕组无关(Motor Specifications — Independent of Winding)

以下规格为所有绕组版本共用的马达特性。数值容差范围:±5%(波动扭矩与铜损容差:±10%)。

马达数据适用于系统固定在约 73,600 mm² 安装板上的情况。(The stated motor data relate to a fixing of the rotary system on a mounting plate with a surface of ca. 73600 mm².)

马达规格 符号 单位 RDDS1-230x115 RDDS1-230x140 RDDS1-230x165 RDDS1-230x190
极对数(Number of pole pairs) P 17 17 17 17
最大工作电压(Maximum operating voltage) U V 600 600 600 600
扭矩(Torque)
极限扭矩 at Iu(Ultimate torque at Iu Tu Nm 110 220 327 436
峰值扭矩(饱和范围)at Ip(Peak torque (saturation range) at Ip Tp Nm 93 186 276 369
峰值扭矩(线性范围)at Ipl(Peak torque (linear range) at Ipl Tpl Nm 65 129 192 256
连续扭矩(水冷)at Icw(Continuous torque - water cooled - at Icw Tcw Nm 37 86 137 189
连续扭矩(无冷却)at Ic(Continuous torque - not cooled - at Ic Tc Nm 17 35 48 61
静止扭矩(水冷)at Isw(Stall torque - water cooled - at Isw Tsw Nm 26 61 97 134
静止扭矩(无冷却)at Is(Stall torque - not cooled - at Is Ts Nm 12 25 34 43
波动扭矩(齿槽效应)at I = 0(Ripple torque (cogging) at I = 0) Tr Nm 0.3 0.6 0.8 1.1
功率损耗(Power Loss)
功率损耗 at Tp(静态,25 °C) Plp W 2790 4059 5327 6595
功率损耗 at Tpl(静态,25 °C) Plpl W 1090 1585 2081 2576
功率损耗 at Tcw(Power loss at Tcw Plw W 455 911 1366 1822
功率损耗 at Tc(静态,25 °C) Plc W 83 133 149 166
热阻与电机常数(Thermal Resistance & Motor Constant)
热阻(水冷)(Thermical resistance (water cooled)) Rth K/W 0.220 0.110 0.073 0.055
电机常数(25 °C)(Motor constant (at 25 °C)) km Nm/√W 1.83 3.03 3.93 4.71
冷却水(Cooling Water)
冷却水流量(Cooling-water flow-rate) dV/dt l/min 1.30 2.60 3.90 5.21
冷却水温差(Cooling-water temperature-difference) Δϑ K 5.00 5.00 5.00 5.00

数值容差范围:±5%;波动扭矩与铜损容差:±10%(Tolerance range for values: ±5% • Tolerance range for values "ripple torque" and "power loss": ±10%)

马达数据适用于系统固定在约 73,600 mm² 安装板上的情况。(The stated motor data relate to a fixing of the rotary system on a mounting plate with a surface of ca. 73600 mm².)

规格如有变更,恕不另行通知。(Subject to modification without previous notice.)

绕组规格(Winding Specifications):RDDS1-230x115 & RDDS1-230x140

绕组版本:WL(低速高扭矩)、WM(中速)、WH(高速低扭矩)。

数值容差范围:±5%;电阻容差:±10%;电感容差:±15%(Tolerance range for values: ±5% • Tolerance range for value "resistance": ±10% • Tolerance range for value "inductance": ±15%)

绕组规格 符号 单位 230x115 WL 230x115 WM 230x115 WH 230x140 WL 230x140 WM 230x140 WH
扭矩常数(Torque constant) kT Nm/Arms 6.73 3.37 1.82 13.47 6.73 3.65
反电动势常数(Back EMF constant) ku Vs/rad 5.51 2.75 1.49 11.02 5.51 2.98
UDCL = 280 V 时之极限转速(Limiting speed at UDCL = 280 V)
at Ip,UDCL = 280 V nlp rpm 163 468 965 42 204 456
at Icw,UDCL = 280 V nlw rpm 350 778 1502 144 352 704
at Ic,UDCL = 280 V nlc rpm 419 878 1656 199 428 816
UDCL = 600 V 时之极限转速(Limiting speed at UDCL = 600 V)
at Ip,UDCL = 600 V nlp rpm 512 1141 2198 226 545 1075
at Icw,UDCL = 600 V nlw rpm 841 1759 3314 383 828 1583
at Ic,UDCL = 600 V nlc rpm 952 1941 3616 465 958 1794
连续运行极限转速*(Limiting speed for continuous running*) ncr rpm 353 353 353 353 353 353
电气参数(Electrical Parameters)
相间电阻(25 °C)(Electrical resistance, phase to phase (25 °C)) R25 Ω 7.9 2.0 0.6 11.4 2.9 0.8
相间电感(Inductance, phase to phase) L mH 21.9 5.5 1.6 43.7 10.9 3.2
电流(Current)
极限电流(Ultimate current) Iu Arms 19.5 38.9 71.9 19.5 38.9 71.9
峰值电流(饱和范围)(Peak current (saturation range)) Ip Arms 15.4 30.7 56.7 15.4 30.7 56.7
峰值电流(线性范围)(Peak current (linear range)) Ipl Arms 9.6 19.2 35.5 9.6 19.2 35.5
连续电流(水冷)at Plw(Continuous current at Plw (water cooled)) Icw Arms 5.5 10.9 20.1 6.4 12.8 23.6
连续电流(无冷却)at Plc(Continuous current at Plc (not cooled)) Ic Arms 2.5 4.9 9.1 2.6 5.2 9.6
零速静止电流(水冷)(Stall current at zero speed (water cooled)) Isw Arms 3.9 7.7 14.3 4.5 9.1 16.7
零速静止电流(无冷却)(Stall current at zero speed (not cooled)) Is Arms 1.8 3.5 6.5 1.8 3.7 6.8
温度(Temperature)
最高绕组温度(Maximum winding temperature) ϑ °C 130 130 130 130 130 130
断路感测器温度(Interrupting sensor temperature) ϑ °C 100 100 100 100 100 100

* 连续运行极限转速定义见型录词汇表(*See glossary)。

规格如有变更,恕不另行通知。(Subject to modification without previous notice.)

绕组规格(Winding Specifications):RDDS1-230x165 & RDDS1-230x190

绕组规格 符号 单位 230x165 WL 230x165 WM 230x165 WH 230x190 WL 230x190 WM 230x190 WH
扭矩常数(Torque constant) kT Nm/Arms 20.00 10.00 5.41 26.67 13.33 7.22
反电动势常数(Back EMF constant) ku Vs/rad 16.36 8.18 4.43 21.81 10.91 5.90
UDCL = 280 V 时之极限转速(Limiting speed at UDCL = 280 V)
at Ip,UDCL = 280 V nlp rpm 0 114 287 0 67 200
at Icw,UDCL = 280 V nlw rpm 78 217 450 45 149 322
at Ic,UDCL = 280 V nlc rpm 130 284 546 94 210 407
UDCL = 600 V 时之极限转速(Limiting speed at UDCL = 600 V)
at Ip,UDCL = 600 V nlp rpm 130 347 703 80 246 514
at Icw,UDCL = 600 V nlw rpm 237 532 1032 164 384 755
at Ic,UDCL = 600 V nlc rpm 308 641 1204 228 478 901
连续运行极限转速*(Limiting speed for continuous running*) ncr rpm 353 353 353 353 353 353
电气参数(Electrical Parameters)
相间电阻(25 °C)(Electrical resistance, phase to phase (25 °C)) R25 Ω 15.0 3.8 1.1 18.6 4.6 1.4
相间电感(Inductance, phase to phase) L mH 65.6 16.4 4.8 87.5 21.9 6.4
电流(Current)
极限电流(Ultimate current) Iu Arms 19.5 38.9 71.9 19.5 38.9 71.9
峰值电流(饱和范围)(Peak current (saturation range)) Ip Arms 15.4 30.7 56.7 15.4 30.7 56.7
峰值电流(线性范围)(Peak current (linear range)) Ipl Arms 9.6 19.2 35.5 9.6 19.2 35.5
连续电流(水冷)at Plw(Continuous current at Plw (water cooled)) Icw Arms 6.8 13.7 25.2 7.1 14.2 26.2
连续电流(无冷却)at Plc(Continuous current at Plc (not cooled)) Ic Arms 2.4 4.8 8.9 2.3 4.5 8.4
零速静止电流(水冷)(Stall current at zero speed (water cooled)) Isw Arms 4.9 9.7 17.9 5.0 10.1 18.6
零速静止电流(无冷却)(Stall current at zero speed (not cooled)) Is Arms 1.7 3.4 6.3 1.6 3.2 6.0
温度(Temperature)
最高绕组温度(Maximum winding temperature) ϑ °C 130 130 130 130 130 130
断路感测器温度(Interrupting sensor temperature) ϑ °C 100 100 100 100 100 100

* 连续运行极限转速定义见型录词汇表(*See glossary)。

规格如有变更,恕不另行通知。(Subject to modification without previous notice.)

ESC
連結已複製!